A limit box is a popular clipping tool used when working with a small region of points. The Quick Limit Box tool uses a single pick in the TruSpace viewer to define the center of the region of interest. A limit box is applied with a pre-defined size around that center.
To create a quick limit box, follow the steps below:
-
Launch the TruSpace viewer from which the region of interest is visible.
-
Enable Quick Limit Box.
-
Adjust the range of the Quick Limit Box in the edit box next to B=.
-
In the TruSpace viewer, switch to the Quick Limit Box mode.
-
In the TruSpace viewer, pick on the desired center point. The CAD viewports are updated with the corresponding limit box.
-
If needed, click Regenerate Points in the Rendering panel to load more details within the limit box.
-
To disable the limit box, use the Limit Box Off command.