Skip to main content
Skip table of contents

Sync Toggles

AUTOCAD PRO REVIT UNTIMATE

TruSpace | Sync Toggles

image-20240402-122255.png

Command Line

  • AutoCAD: CWTSTOOL

This command opens a dialog with synchronization settings. It also appears automatically when opening TruSpace or KeyPlan.

Note: Do not close the dialog unless you want to disable TruSpace synchronization, where the CAD viewpoint changes to match the TruSpace viewpoint.


Using the Tool

When the tool is activated, the TruSpace Toggles dialog appears with the following settings:

image-20240402-123244.png
  • Enable Sync: This is a toggle item that enables or disables the viewpoint synchronization with the TruSpace viewer. When synchronization is off, the CAD viewpoint does not update to match the TruSpace viewpoint.

  • 3D Point: When enabled, CloudWorx submits the 3D pick from the TruSpace viewer to the CAD command line. This pick can be used by CAD commands that accept 3D coordinates. Use Pick on Cloud for CloudWorx commands.

  • Pick on Cloud: When enabled, CloudWorx recomputes the pick made in the TruSpace viewer based on the closest cloud points visible in the CAD window. Recomputation may fail if there are not enough points near the pick or when the points are clipped or hidden in CloudWorx. Use 3D Point for non-CloudWorx commands.

  • View Point: When enabled, the viewpoint of the active CAD viewport automatically updates to match the TruSpace viewpoint. When needed, use the Regenerate Points command to load more details.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.