Skip to main content
Skip table of contents

TV Navigating in TruView VR

There are three primary navigation modes - WalkThruFlyThru and Teleport. There are also some actions tied to the joysticks on the right and left controllers.

Teleport 

The teleport tool is always active. It can be activated by holding up on the joystick on the left or right controller. While holding up on the joystick, move the cursor around to select the location that you would like to teleport to. If the cursor is red you will not be able to teleport there. Releasing the joystick at this point will do nothing. If the cursor is green when you release the joystick, you will teleport to the highlighted location. 

Flythru

The Flythru tool allows you navigate through a project in a flying manner. The camera will move in the X,Y and Z direction that the user is facing.  The Flythru is active by default. If it is not active it can be activated by selecting it in the main toolbar. Activate the main toolbar by selecting the menu button on the left controller. Expand the navigation menu and select the Flythru tool. When the Flythru tool is active, you can fly through the project by holding down the trigger under your index finger on the left controller.

Walkthru

The Walkthu tool allows you navigate through a project while remaining at the same elevation. The camera will move in the direction that the user is facing.  The WalkThru tool can be activated by selecting it in the main toolbar. Activate the main toolbar by selecting the menu button on the left controller. Expand the navigation menu and select the Flythru tool. When the Flythru tool is active, you can fly through the project by holding down the trigger under your index finger on the left controller.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.