Skip to main content
Skip table of contents

Plan View

This command has two behaviors:

  • If the current orientation is Elevation View, it modifies the coordinate system so that Z-axis becomes the vertical axis.

  • If the current orientation is Plan View, it toggles the X-axis and Y-axis.

Requirements

No selection is required to launch the command.

Notes

  • If it becomes the WCS, the unnamed UCS may be deleted after the edition.

  • See Create UCS for additional information.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close