This command converts a CloudWorx cloud (Read-only) to a standard cloud. Thus, you will be able to use all functions.
Requirements
Load a CloudWorx cloud and launch the command.
-
Set Maximum number of points to convert. A selection of most representative points will be done to the CloudWorx cloud according to this limit. Optionally disable the import of intensity.
-
Note that if you have an active limit object, only unclipped points will be converted. In this case, a dedicated message will be displayed.
-
If the conversion takes a lot of memory, a dedicated message will indicate the amount of required memory and the current amount of free memory.
Tip & Trick
-
To extract a part of a CloudWorx cloud, you have to clip it using limit plane, slice or box functions before launching the command.
Notes
-
For IMP data, the number of kept points should be lower (half of requested points) and the maximum is about 50 million.