This command constructs new CAD curves.
Requirements
No selection is required to launch the command.
-
Click points inside the graphic scene. If you need more information: refer to Define points. These points will be the "passing" points for the curve (passing exactly by all points).
-
If you want to delete the last point, press Del or BackSpace key.
-
If you want to exit the command without validating the current CAD curve, use the ESC key.
-
When you have finished the CAD curve, press Enter key. You can then start a new CAD curve.
-
If you have finished drawing CAD curves, press again Enter or ESC key to close the dialog box.
Tip & Trick
Press C to close / unclose the curve.
Notes
Positions of control points are reset after each new click or point deletion.