This command allows you to set the parameters of the connected measurement device.
Requirements
Connect the arm, and launch the command.
-
Scan measurement mode section provides you the possibility to modify the action of the measurement button in case of SCANNING:
-
One measure per push: user needs to click one time to measure only one stripe.
-
Continuously when button down: user needs to keep the button pressed to scan clouds. If user presses the button, the measure is launched and when he releases the button, the measure is stopped.
-
On / Off switch: user needs to click twice, one time to launch and another time to stop the measure.
-
-
Use sound must be checked if user wants to make a sound when the arm buttons are pressed.
-
Grid angle: the limit angle above which a new grid will be created while scanning.
-
RDS Control Panel button will be available if the connected arm is connected through RDS. It will open the specific arm interface.
Notes
-
All options defined in this command are also available directly on the arm software interface.
-
If there is an error while connecting the arm, the command will not be displayed, and replaced by this message: Retry connection button will restart the connection.