Skip to main content
Skip table of contents

Limit Plane

This command creates a limit plane and hides the data on one side of that plane. 

Requirements

No selection is required to launch the command.

Click a point using Define points. A limit plane is created in the scene:

  • View Left is going to clip the cloud in the -X direction.

  • View Right is going to clip the cloud in the X direction.

  • View Front is going to clip the cloud in the -Y direction.

  • View Back is going to clip the cloud in the Y direction.

  • View Top is going to clip the cloud in the Z direction.

  • View Bottom is going to clip the cloud in the -Z direction.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close