Draw

This command constructs new polylines.

Requirements

No selection is required to launch the command.

1. Select the method needed to create points in the 3D scene. If you need more information, refer to Define points.

2. Click points to create the polyline.

3. If you want to delete the last point, press Del or BackSpace key.

4. If you want to exit the command without validating the current polyline, use the ESC key.

5. When you have finished the polyline, press Enter key. You can then start a new polyline.

6. If you have finished drawing polylines, press again Enter or ESC key to close the dialog box.

Tip & Trick

• Close and validate the current polyline by pressing the C key.

• Press the CTRL key to draw a segment which is vertical or horizontal to the current view.