Skip to main content
Skip table of contents

CW TruSpace Measure Distance | Point-to-Point

Measure Distance allows the user to measure between two pick points on the point cloud. The distance measurement will be displayed in the measurement units defined in the viewer settings.

Mouse Control: In Measure Distance mode, click to pick the first measure point, then click on another location to set the endpoint.  

Pipe Snapping

 The distance measuring tool has two snapping options that allows for snapping to a pipe centerline or the edge of a pipe. These snapping options can be toggled on or off at any time while measuring. These tools will automatically snap to the pipe centerline or edge while measuring. If the tool is unable to detect a pipe it will display an error message.

Pipe Centerline (TruView Desktop only)

This tool will automtically detect the centerline of the pipe and snap to it. The tool will snap to the closest edge of the pipe to the other end point of the measurement. The snapped point will adjust after the the secound mouse click.

Hotkey: C

Pipe Edge (TruView Desktop only)

This tool will automtically detect the edge of the pipe and snap to it.

Hotkey: B

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.